In this tutorial I show you how to fix a leaky Delta bathtub faucet with 2 handles.The moen cartridge video I did a few years back, and the Delta bathtub fau Once the water flow stops, cover the drain with a towel. This will prevent small objects from falling into the drain as you go through the faucet repair process. 3. Remove the Cap and Handle. On the faucet handle you need to repair, use a flathead screwdriver to pry the plastic cap off. This will reveal the screw.
Once the valve is loose, take it out of the housing. Remove the screw in the end of the valve, and take out the washer. Replace the old washer with a new one of the same diameter and thickness and tighten the screw holding it on. Wrap the housing threads on the outside of the valve with Teflon tape to prevent it from leaking at the handle.
To fix a leaking Glacier Bay bathroom faucet, all you need to do is locate the leak and replace the cartridge. Outlined below are the exact steps you need to take to fix your bathroom faucet by yourself. Step 1. Turn off the water by closing the water valves below the faucet. Step 2. Pry out the rubber cap on the handle with a knife if there is

Once the handles are off and set aside, loosen the cartridge retaining nut. Use a pair of tongue-and-groove pliers or a pipe wrench to loosen the nut. Once it’s loose, finish unthreading and removing the nut from the faucet body by hand. At this point, check for a screw in the top of the cartridge. In some faucets, there will be a brass screw

Is your bathroom faucet leaking? In this episode of Repair and Replace, Stephany shows how to replace the 1/4 turn washerless cartridges in a 2 handle bathro
Step 2: Removing the Faucet Handle. Now that the water supply is safely turned off, you can proceed with removing the faucet handle. Follow these detailed steps: Locate the Small Screw or Cap
In this video I will show you how to fix a leaking bathroom faucet.Parts and Tools Used:Screw Driver - http://amzn.to/2xv7Da4Crescent Wrench - http://amzn.to
Check the end of the set screw to see if you need a screwdriver or a hex wrench to loosen it. Turn the set screw counter-clockwise until the handle is loose enough to pull straight off. Most times, you won’t need to remove the set screw completely from the handle. 5. Determine if you have a ball or cartridge faucet. Remove shower cartridge. family handyman. Pull off the stop tube. Pry up the cartridge retaining clip with a small screwdriver or awl. Remove the handle washer and then twist the cartridge stem loose and pull it out with pliers. If it’s stuck, use a special cartridge puller. Unscrew the hex screw and hex nut until threads are visible. How To Fix A Leaky Bathtub Faucet With Two Handles 1. Turn Off the Water Supply. Before you start any work, turn off the water supply to the bathtub. Then locate the main water shut-off valve for your home and close it to prevent water flow to the faucet. 2. Remove the Handles. To access the faucet’s internals, you’ll need to remove the .
  • 68gicaluxg.pages.dev/15
  • 68gicaluxg.pages.dev/73
  • 68gicaluxg.pages.dev/87
  • 68gicaluxg.pages.dev/44
  • 68gicaluxg.pages.dev/296
  • 68gicaluxg.pages.dev/376
  • 68gicaluxg.pages.dev/341
  • 68gicaluxg.pages.dev/288

    • fixing a leaking faucet handle